Seaward PrimeTest 200 Instruções de Operação descarregar pdf (Página 12)

PrimeTest 100 Operating Instructions

• The unit will proceed with the Insulation and

Leakage tests.

Note: The power switch on the appliance under

must be in the ON position to perform an

insulation test. If no appliance is detected

the PrimeTest 100 will display the

following.

• Check that the appliance power switch is in the

ON position. The test will automatically proceed

if the appliance power switch is placed in the ON

position.

• If the LO LOAd enunciator remains on the

display, the load presented by the appliance may

be too small for the PrimeTest 100 to detect. In

this case, press the test key to continue.

• If the Insulation Resistance is greater than the

factory set limit a tick is placed next to the Riso

enunciator. If the Leakage current is less than

the factory set limit a tick is placed next to the

LEAK

enunciator.

• The PASS enunciator is illuminated.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Seaward PrimeTest 200 Instruções de Operação Página 12